FIRST YEAR ITI ENGINEERING DRAWING 2019 PAPERS


ITI ENGINEERING DRAWING 2019 PAPERS TWO YEAR TRADES

GOVERNMENT OF THE NATIONAL CAPITAL TERRITORY OF DELHI 
DEPARTMENT OF TRAINING & TECHNICAL EDUCATION 
MUNI MAYA RAM MARG, PITAMPURA, DELHI – 110 088
ALL INDIA TRADE TEST JULY-AUGUST 2019 
PAPER-IV (ENGINEERING DRAWING) 
ANNUAL SYSTEM (YEAR-I)
ALL 10th PASS TWO YEAR TRADES


TIME: 3 HOURS.              Max Marks: 50


Note: Attempt all Questions.



1. Draw the following (Any Four). (5x4=20)

  1. Neat Sketch of Slotted Nut.
  2. Any Two Type of Screws with Their Nomenclature.
  3. Inscribe a Regular Heptagon in a Circle if The Length of One Side of The Heptagon is 20mm.
  4. A Plain Scale of 1cm=5m And Show 37m on it.
  5. Free Hand Sketch of Cross Peen Hammer.


2. Figure Shown Below is Horizontal Shaft Bearing. Draw the Following Orthographic Views in third Angle Projection.  (10X3=30)

  • Elevation View (Front View)
  • Side View
  • Top View

All Dimensions are in mm.


After Passing iTi Career Option | iTi के बाद क्या करें? Apprentice या Job 


Tags: iTi ENGINEERING DRAWING Papers, Previous ED paper, iTi Fitter Papers,iTi Paper2020,ITI ENGINEERING DRAWING 2019 PAPERS TWO YEAR TRADES

Post a comment

0 Comments